Sinuous FJ200 Mod has Some Problems - Wismec Instruction

The Setting of Preheat Function: 

(1). When powered on, press the fire button and right regulatory button simultaneously and then you enter the preheat setting menu.
(2). Press the fire button to switch between preheat power and preheat duration.
(3). Press the left or right regulatory button to decrease or increase the parameter.
(4). Long press the fire button to confirm.

Adjustable Timeout Duration: 

Due to different vaping habits, you’re allowed to set the timeout duration from 5 to 15 seconds as you prefer. Press the fire button and right regulatory button simultaneously to enter into the menu system. Press the right regulatory button to enter the timeout duration setting. Press the left regulatory button to set the duration and then press the fire button to confirm.

Once the duration is set (like 5 seconds), when you hold the fire button and vape over the pre-set time, it’ll display “OVER 5S PROTECT” and shut down automatically. Press the fire button 5 times to restart.

Charging Protection (ENU): 

While charging, if the temperature of the device is higher than 45℃, it’ll display “Battery Too Hot”. On the contray, if the temperature is lower than -5℃, it’ll display “Battery Too Cold”. While charging, when the temperature of the device reaches to 50℃ or higher, the device will stops charging until the temperature drops down to 45℃ or lower.

The Setting of ENU: 

(1). When powered on, press the fire button and right regulatory button simultaneously and then you enter the
menu system. (2). Press the right regulatory button two times to enter the ENU menu. (3). Press the left regulatory button to shift between “ON” and “OFF”. (4). Press the fire button to confirm.